Lỗi định dạng email
emailCannotEmpty
emailDoesExist
pwdLetterLimtTip
inconsistentPwd
pwdLetterLimtTip
inconsistentPwd
In the previous blog, we introduced the different classifications of cnc milling machines. Today we will talk about the maintenance of various parts of desktop cnc milling machines.
The taper contact between the spindle taper hole and the tool shank keeps the coaxiality between the tool and the spindle center. If the spindle taper hole is not clean, it will cause the deflection and non concentricity between the spindle and the tool center, which will affect the accuracy of the workpiece.
Therefore, it is very important to keep the spindle taper hole clean. Before installing the cutter, clean it with compressed air and remove the dirt from the taper hole.
Clean the dirt on the spindle fan every three months.
For machining centers that are not used for a long time, be sure to brush oil first to prevent the main parts such as the main shaft from rusting.
It is a hollow shaft structure, with a conical hole at the front end, which is matched with the tool handle; The rear end is equipped with an automatic tool clamping mechanism.
There are two kinds of common spindles: spindle unit composed of belt drive and gearbox and motorized spindle. Motorized spindle is that the motor is directly installed in the spindle, and the motor is connected with the spindle to directly drive the tool movement.
It is composed of knife handle, collet, butterfly spring, piston and cylinder, as shown in Figure 3-18. The air cylinder is supplied by the air compressor.
An end face key is installed at the lower end of the main shaft, which is matched with the tool handle for driving torque. The taper of the tool shank and the taper in the lower hole of the spindle only play a centering role and cannot transmit torque.
It refers to the automatic removal of chips and dirt in the spindle hole by compressed air to ensure the correct positioning of the cutter bar.
It is divided into stepping motor drive and AC servo motor drive. Stepper motor drive has no position feedback and poor accuracy and load capacity.
It is only used in AC servo control system. Generally, it detects the speed and phase angle position of servo motor, which is called closed-loop or semi closed-loop detection device.
We are the best desktop cnc mill supplier, we can provide high-quality desktop cnc mills and Cnc Machining Service, any interests, welcome to contact us.